I am about to do a tune-up on my brothers 1993 warrior. Can anyone give me the valve clearence specs?

 

I used a Warrior manual when I rebuilt the motor on my Wolverine(same motor). The specs were intake: .0024-.0039 in. or .06-.1 mm , exhaust: .0063-.0079 in. or .16 -.20 mm. This is on a cold motor (do it in the morning,let it run,cool for a couple of hours,and recheck,if you have the time) I do it like that because the fenders on a Wolverine are a pain to take off to get at the valves,yours aren't quite so bad.

 

thanks for the info. Is the intake the front or the rear valve?

 

intake is rear - closest to the carb.