I'll be installing a kill switch on my Raptor and the instructions just reference the "engine pulse trigger wire". Can anyone help me locate (color code, convienient location) this wire ? Without a service manual I want to be sure I do it right the first time.

Thanks, Eric

 

The small wire with the female connector on the coil is the one you want. Think its Orange. Its best to make a small wire with a male, female end and the kill switch hooked all in one then you can just disconnect the coil wire and reconnect it with out cutting any of the bikes wiring!! Hope this helps.

 

It's a simple hook up,
Splice one wire into the orange coil wire (I used one of those splicing clips so no wire cutting was needed) , The other wire goes to the frame for a ground.
That's it your ready to go!!

 

Cool, thanks !