Hi,
I just purchased a 2006 Vinson Lt-A400F 4X4. I got it for a good price knowing it had brake problems but ugh, worse than I thought. Oh well.
I need to replace the brake disks and pads which I have already been ordered online. My problem now is getting out the Allen bolts holding on the disks and the castle nut for the rear wheel. The castle nut does not budge with an air gun. I applied a little heat and tried again but my torch nozzle screwed up and it still didn't come off. I have similar problems with the Allen bolts. I have seen a few good suggestions online to get them off but they will destroy the bolt / nut.
Two questions:
I am going to the Brantford / Toronto area soon. Is there any place that carries brake / wheel hardware or an online order site in Canada?
If I buy online in the states, will it be the right thread? I would guess ours is metric.

 

I like Motorcycle Parts and Accessories, Motocross Parts & Accessories, ATV Parts and Accessories, Snowmobile Parts and Accessories, Marine and Bicycle Apparel, Parts & Accessories Canada good prices and ship right to your door.

Their good to talk to and have a free 1-800 number .

Are you sure its not a 400 Eiger or KQ?
The Vinson was a 500 only.

 

TLC
Sorry it is a 500. My Arctic Cat is a 400. I'll check out the site, thanks

 

The threads are metric but quad makers use a lot of metric fine threads so you need to know both the diameter and pitch of the old bolts. Sort your welding torch out, heat and an air wrench is the best way to get nuts and bolts to shift. Impact drivers are best on allen screws.