Thanks for the link. I'll tray and call them on Monday.
M.W.Q., thanks for trying!
I have found the correct gearbox from one of the suppliers I have called, but they wanted 469.00 + shipping for it!
I haven't found just the cases(which is all it really needs) or a forward only set up.
I have found similar quads for sale for 450-700 dollar range, so I just can't justify spending that much on this one.

 

Hello Gents and Ladies,
I have the above and do not have the seal or bushings
for the rear hubs. Any ideas where I can find these?

mcn510

 

Welcome to the forum mcn510!

chinese atv part has 5 pages of seals and bearings

Bearings And Seals : Chinese ATV Parts, Kazuma ATV Parts, Sunl ATV Parts, Roketa ATV Parts, BMX ATV Parts!

 

Hard to believe you can get a whole quad for the price of the gear box...

 

Thanks for the info but what I am looking for is the
bushing that fits over the shaft and the seal that the
wheel cap fits on. If that doesnt make sense I may
photo it.

 

My mistake.... do you need the axle tube and the washer the rubber cap goes on?

 

Yes,
I may be calling it the wrong thing. It is a small
bushing that is about 3/4" in length that fits over
the axle. There is something missing that holds the
rubber dust cap on as well. I have the castle nut,
cotter pin, and small flat washer. Thnks for bearing
with me and pardon the bearing conversation again.

 

OK then its not the axle tube...does this bushing go on the axle and in the hub?

The rubber cover fits over a large washer...approx 2" outside diameter and 1/8" thick...

 

Yes it fits right over the axle spines into the hub. Just looks
like it is to stabilize the hub on that side.

 

I havnt been able to find that part on any website...If you google Yamoto Parts a few suppliers come up..You will need to call places that sell Yamoto parts and seee if they have or can get that specific part..