2008 hi-bird 250 wont crank over inless jump solenoid
#1
2008 hi-bird 250 wont crank over inless jump solenoid
I have replaced the coil and whole starter kill switch assembly started fine up in till that point put old one back on it still wont crank over so put new one back on so I jumped the solenoid it cranks over just fine and starts any help will be a plus thanks
#5
i know you said "the switch is new" but you could have a blade that backed out not making contact or a wire pulled loose from the switch or a broken wire inside the jacket. use your ohm meter/multimeter and ohm the wiring out and you'll find it. if you can jump and solenoid and she starts, then your problem is up at the key or pushbutton start switch that Zrock is talking about.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)