Trying to figure out why I keep having fuses blow. Here is what has been replaced: Ignition Solenoid, Ignition Switch, Ignition Relay, CDI, Voltage regulator, Stator, Battery, Kill switch, and wiring harness. Any ideas what would be causing the short? Checked all the plugs and grounds. Still losing fuses to this thing. Any help would be appreciated!

 

Maybe your fuse is not high enough?

 

Hey dmills5966 where did you buy your part's at? I have a 2006 Hi Bird 250 and would you have a manual for this? Thanks

 

Pull the plastics and start checking the whole wire harness. their is a short in it someware.

 

I have a 2006 Hi Bird 250cc atv if any one pushed the kill switch at anytime you have to push it again . Found that out the hard way I pushed it to turn it off and would not start after till someone at a different site told me about it hope this helps.

 

I had a similar problem with a Yam Big Bear last week and put a high wattage test light across the fuse terminals, if it lights brightly you have a short somewhere, you can then disconnect wires and see which one makes the light go out. (It was the CDI on the Yam).