So I took off the carb and cleaned it out and in doing so I just took the throttle cable out of the box on top of the handle bars. Now my throttle is non responsive. Can anybody help me on routing the cable and maybe adjusting it when I get it back on?

 

when you say non-responsive, do you mean it's not opening or closing the throttle at the carb? if you post a pic, i'll compare it to my 250 and see if i can help.

 

I finally figured it out. It needed the gas tank setting on it and there is a small cut out on the bottom for it to run through and it works fine after I got it ran. Now my question is, my handlebars are turned to the right a little bit after I straightened the steering shaft a little. Can I use the tie rods to correct it? And my left front tire is setting crooked on the ground. Is there anything I should look for? I see no broken or bent parts.

 

Yup, you answered your own question.