What does everyone do?

 

You might as well ask people to send you nude pictures of their wives.[img]i/expressions/face-icon-small-happy.gif[/img] Not many will give up their secrets and those that do are probably not worth getting.
As far as tuning, adjusting the float level is probably the most over looked item.

 

Remove them and replace with FCRs:-)

Seriously, what kind of improvements are you looking for?

 

I'll second that, replace em with FCRs instant improvement.

 

Send them to Bob along with a check for 300 and smile when you re-install. Mine rip know. Sixsixt is about 100 percent right.[img]i/expressions/face-icon-small-smile.gif[/img] You get a dual pingle valve with that also

 

Thats a good price. I know that Pingle Valve is high as he77.

I say poop on $850 FCRs and buy a couple hundred dollar Lectron.[img]i/expressions/face-icon-small-happy.gif[/img][img]i/expressions/face-icon-small-wink.gif[/img]

 

Yup, top secret. But I'll tune em for about $150, the mods are permanent though! I'll do the nonpermanent mods for $100.
Or you can get in there & jet until your fingers bleed & brake a few things....... its ok, you can replace the parts!
Or just start on the rich side & jet down on the mains one size at a time untill she runs blubber free.
Its real time consuming but worth it when you get it right. [img]i/expressions/face-icon-small-smile.gif[/img]
Leave clips on pos 3, that's right, no matter what the stinking jet kit tells you. It is acceptable to adjust the fule screws & pilots if necessary.

 

Watching

 

I'm getting a little paranoid.[img]i/expressions/face-icon-small-shocked.gif[/img]

 

Sounds like you have a guilty conscience! I'm just watching the thread.

[img]i/expressions/face-icon-small-happy.gif[/img]