I'm trying to remove the warning labels from my outlaw, I tried wd-40 and a blowdryer, no luck..

Any suggestions??

MIS

 

Did you get the decal hot enough with the blow dryer? That usually works fine. I just parked mine in the sun for a while and they peeled off easily. I removed the glue residue with Goo Gone.

 

power washer works best in my opinion. just angle the jet at the edge and work it off. you'll probebly have sticky residue afterwards, which WD-40 will get off.

 

I agree......pressure washer.........also heat gun, but be careful

 

Pressure washer works well if you have one. If not, let it set in the sun like eurozx 3 said. Then, again, use goo gone. Why do dealers have to put 50 stickers on there? If I want to know how something works, I'll read the d@nm manual.

 

so they dont get sued by some dumbass bitch mothers against four wheelers person

 

Yep, it is all CYA for the manufacturers. So the warning labels on the Outlaw are just stickers, not the pop-riveted aluminum plates everyone esle uses?

 

Thanks guys.. I will be trying to get them off today..


Thanks heaps..


MIS



--------------

 

yep.