Hey there, new here. After blowing up my 1996 YZ 250 bike I got a YZ250N off ebay with a pipe and silencer for a pretty good price so I decided to install it in my Yamaha Blaster. I got my swing arm supports modded and my engine in place, cut one of the lower suspension supports so my YZ pipe would fit through (will re-enforce) The only problem is my pipe comes about an inch and a half short of my exhaust manifold on the 250. I can't find a piece of pipe to fit over the exhaust and inside of the pipe, any ideas? Anybody out here that has done this mod?