i was jetting my bike and knocked the washers and spacers out of place. now i don't know which washer goes where. I've seen the diagram of the carb and the diagram that came w/ the jet kit. I can't distinguish which washer is which. when looking at the washers one is thicker than the other. does anyone know where the thicker washer go?

 

well if anyone is planning to jet their bike please look at the needle set up and let me know where the thicker washer goes, or if anyone feels like pulling their needle out and looking at it that'll be great too. thanks[img]i/expressions/face-icon-small-smile.gif[/img]

 

Did you put in stock jets or not?
it really does not matter what order they are in.. Just slap them below your E clip and your desired position and call it good
I run them all below then 3rd clip on the needle. Its the Dyno jets..