i'm needing the specs for the 6 small bolts on the primary clutch.. i know the big bolt is 40lbs.. but the smaller ones i'm unsure of.. one site said 90 ft lbs.. and one said 90 in. lbs.. and i 'm thinking the 90ft. lbs would be WAY TOO MUCH....also i put in the hpd speed kit today and when i was test riding it i could hear a very little "chatter" in my clutch side.. i put it in neutral and reved and i can still hear it but not at idle.. any suggestions as to what this could be??i know i should have a manual but i just bought the quad day before yesterday and it didn't come with one.. it is a 2000

thanks in advance

Joey

 

The proper torque is 90 in lbs for the six small bolts.

 

The torque is 15. do not torque to 90. I did and snapped the bolt. What a bitch to drill out.

 

Madcap, 15 inch pounds can be done with your fingers. The correct torque on the 6 primary clutch outer bolts are 90 inch pounds. DMSHEE, is the clutch cover rbiing the clutch in any way? Bubba

 

no actually it's not rubbing and doing great now.. i had to reseat the cover a few times because i couldn't get it in there perfect, but i've gotten it on straight now and with the hpd speed kit, it really woke it up... although i wish it had a little higher engagement.. but maybe later i'll change it... i'm just using it for leisure riding and i race hare scrambles.. so i'm hoping this is going to be a pretty good woods bike (besides the fact it weighs almost a ton) i really got out and rode trails today and i'm happy with it.. much better woods machine than my banshee..

thanks for the help guys.

 

Sorry guys. The key here is inch pounds. I torqued to 90 foot pounds. So the proper Torque is 15 inch pounds.