has anyone had thier brake stop working yet. My lever went right to the bar, causing me to roll over down a gully. Afterwards when i tried to see what the HE&& happened they were working fine and havent done it since. Could air have gotten into the line?

 

Fluid level full to the top? If not with some extreme angles you can get air in the master cylinder and then it bleeds back out when you get it upright. Or you could have a bad cylinder, either master or one of the wheels.

 

THANKS BEAR

 

I have also had it happen a few times. Pulling the lever almost to the bar before the brake starts to work...must be getting a little air somehow....