Newbie with general ??s for '04 500
#11
belt change
It's pretty easy to change the belt on an auto equipped a/c. You gotta pull off the belt housing. Then using one of the belt housing bolts, thread it into the hole on the pulley closer to the rear of the bike. This will open up the pulley. You can then slide the belt on the two pullies. Take the bolt out and your belt is tight. Replace your belt housing cover, being careful to place the seal correctly so it will stay water-tight.
Thread
Thread Starter
Forum
Replies
Last Post
braap123
General RUV / UTV Discussion
0
09-07-2015 12:58 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)