2000 Arctic cat 300 4x4x
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
Hi guys,
Could some one please help, I need a wiring schematic for my 2000 300 4x4 red. I only have 3rd and 5th on the dash and cant use the starter button. I can pull start or jump the solenoid. All the fuse's work as they should, Once its started it runslike a dream. any help would be awsome!
Thanks guys
Could some one please help, I need a wiring schematic for my 2000 300 4x4 red. I only have 3rd and 5th on the dash and cant use the starter button. I can pull start or jump the solenoid. All the fuse's work as they should, Once its started it runslike a dream. any help would be awsome!
Thanks guys
#2
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
did you test the small wires on the selenoid. Unhook the small wires from the selenoid and put to paper clips in the connector and hook up your volt meter to the paper clips and push the start button if you get voltage replace the selenoid. take the gas tank off and check for a broken wire by the steering post. on your gear indicator lights you are most likely going to have to replace that whole assembly.
#3
#5
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
check all your wires for rubbing and or "chewing" a mouse got a hold of my power wire coming from the starter to the fuse box and screwed the bike out of power to everthing. I repaired the wire and its running fine now....that being said...i had to take the entire wiring harness out to find the problem...i hope you can find the issue without doing that.
Thread
Thread Starter
Forum
Replies
Last Post
Customer Service #1
Arctic Cat
73
05-15-2020 08:46 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)