exhaust and jetting question
#1
exhaust and jetting question
i have an 1984 200s i ordered a camshaft out of a xr200r off ebay for a few bucks. for exhaust i wanna use the muffler at the link below:
http://doityourself.com/ori/200x200/7872930.jpg
would that be a good muffler for power? or would that muffler or straight pipe hurt my engine any if i have it jetted correct? what should i run for a main jet and a pilot jet, or should i just lower the clip? how can you tell if you have the piliot jet tuned correct?
also when i shift into 1st and second gear, sometimes i push down to shift and it sticks and i have to help it up. what do you think the problem is?
http://doityourself.com/ori/200x200/7872930.jpg
would that be a good muffler for power? or would that muffler or straight pipe hurt my engine any if i have it jetted correct? what should i run for a main jet and a pilot jet, or should i just lower the clip? how can you tell if you have the piliot jet tuned correct?
also when i shift into 1st and second gear, sometimes i push down to shift and it sticks and i have to help it up. what do you think the problem is?
#2
exhaust and jetting question
I have to tell you that the jetting you have asked about in 3 post now has to be found out by YOU THE RIDER!!!!!!!!! You will have to install the mods you want, then jet it accordingly! 2 bikes built the same may run with different jets. You can not just say that I have this, what jet do I need.
If you want to know exactly what each part of the carb does, and how to jet it correctly, then read
THIS
If you want to know exactly what each part of the carb does, and how to jet it correctly, then read
THIS
#3
#6
Thread
Thread Starter
Forum
Replies
Last Post
bpegram84
Kids Quads & Other ATV's - Ask an Expert!
0
07-22-2015 08:15 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)