1983 200e honda big red easy way to put a drive chain on
#1
#2
1983 200e honda big red easy way to put a drive chain on
Remove the chain cover, take out the masterlink of the chain. Make sure it is in neutral, take a piece of wire (like a clothes hanger) and attach it to one end of the chain. Feed the wire in above the front sprocket and pull it through underneath. Wrap it around the rear sprocket and replace the masterlink. Then tighten it. Make sure your rear bearings are good or it will just come off again.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)