Where is the best place to pick up a valve spring tool?

 

10 or 12 inch "C" Clamp and an impact socket. Get your welder out and make your own tool. You will not find one.... can't even order it. Snap On, MAC, CORNWELL.... no one has one like it.

Let me know if you want me to make you one. Send me the 20 and change, and I'll bust it out for ya. No big deal really. If you got a welder, your almost done.

 

Teebone:

Preacher can make you one also.

He made Jeffnrivercity a nice one.

Me, I'm just going to take the DS to him and have him pull the head and replace the springs.

Let me know. You could hook up with him on a weekend and have him do the work for you. Not too far of a drive and his shop rate is VERY reasonable.

He doesn't like to work on engines in the chassis but, I'ld just take your Warrior there with the quad in at and leave it at his place for a week. He'll probably have it done in a day or two and you could pick it up the following weekend.

Give me a call and I'll let you know what I've done in the past.

He does most of the work for The Bom Racing so, you know his attention to detail is top notch.

 

Cynick just came up with a good idea. I'll make 3 or 4 and take them to DS Days. I'll sell them for what I've got into them plus like 5 bucks. Not to worry, you'll like them. I use mine just about every weekend or every other weekend. I think it will end up costing about $20 or so. Not making any money and not looking to start a business. Just going to pay for the parts. I think the parts will end up being like $18 or so.

If I need to make more than 3 or 4, put your orders in now.

This tool will work on every head out there. From 300 - 850's. I've used it on just about everything you could imagine and it is still like new.

Let me kow guys.

Tuesday will be the make or break. If you let me know later than that..... your SOL.


[img]i/expressions/face-icon-small-wink.gif[/img]

I threw that wink in for Choose.