Anyone know where I can get an axle carrier (if available) with a zerk fitting. I found them on Ebay but they are dual row bearings. I prefer to stick with tapered bearing setup.

 

I don't think it would be that hard to put a zerk on a existing carrier. Should just drill and tap at a spot where there is some meat.

 

yea the only problem with that though is you might have to cut out a groove in the swingarm so when you go to take out the carrier next time you won't have to be messing with it or just make it so you can get to the zerk so you can take it out when you need to take out the carrier.