I still will be able to use the heel guards right?

 

Yes, they would just need a trim.... I cannot remember where exactly, but you will be able to see it once the tires are on..... Very simple to do

 

Cool Thanks for the info.

 

2000 F-150 XLT Supercab 4.6L V8
White w/Grey interior
4 wheel ABS, new pads all the way around last weekend.
Less than 5K on 80K tires.

Well maintained with lots of Interstate hiway miles. Purchased to make cross country trips while on the Marine Corps Rifle Team. Been back and forth across the 40, up and down the 95, across the 80 and 70, all over the East Coast, South East, and MidWest. Just rolled over 100K mostly hiway miles. Was not a daily driver until recently, but has many many trips to Glamis, Dumont, Johnson Valley, Sunfair dry lake bed, and Ocotillo Wells.
You won't be disappointed in this well maintained truck. KBB is $8965 the way she sits, I'll take way less than that considering it's in the way of the F-350 PSD and I'm tiring of paying insurance on something that doesn't get driven since the purchase of the Diesel. Many carefree years left in this old Ford, make her yours.

 

Im in need of a carb real soon, im looking for a TM45 or a Lectron44?

 

Still have an '02 Baja for sale w/ ac nerf bars, and parts from an '03 DS, and now parting out a complete 2001 DS!

 

I got some stuff in the way

Vortex ignition 01 to 06 ( only ran for about 1 or 2 trips)
1 Set douglas rear wheels Black label
AC nerf bars
Stock Swingarm 05
22'' 10 paddle extreme (75%)
LM1 Tuning system set up for a DS w/realtime gauge. ( needs new O2 sensor)
Full stock exhaust
Front fenders


I need a +6 swingarm Preferably an ACE. Will swap for my +4

 

I have a 04 YFZ with a 99mm bore ice cube cylinder, +1 valves, ported head by FTZ, web +5 cams, 4m crank, 1-3 override tranny, lightened A-arms with spindle mount rims and tires, JJ&A drag axle, and a +6 light weight swing arm. The cylinder, head, valves, cams, and piston are brand new havn't even been installed yet.

The 05 YFZ has a 98mm bore Nmotion cylinder with slight port work done, +4 light weight swing arm, and lightened A-arms for spindle mounts not yet installed. The cylinder has about 20hours on it and has just been freshened up with new 13.5 to 1 piston with less than an hour on it. I am needed to sell one or the other to get myself out of a bind so make serious offers please.

 

oops.

 

Skat trac (Mohawks front tires on stock faded gray rims)
Stock front bumper (See in 8th pic in my profile) (SOLD)
Stock handbar clamps with black plastic cover.
Stock foot pegs with out kick ups.
Stock heat shield for the baja stock pipe "NEW" (muffler)

All of this is just laying in the garage and I can't seem to find my way to the car.