wiseguy90
what part of MS. are you in? I can try and post a picture. I know I can e-mail you a pic if you give me your address.

The snorkel isn't hard at all.
I used:
10' of 1.5" flex pvc pipe (like on a hot tub)
inch & half(1.5") pvc 45. 2ea.
inch & half pvc 90. 6ea.
2" pvc 90. 2ea.
2" cuppler pvc 2ea.
2" to 1.5" pvc reducer 2ea.
a 2" to 1.5" black rubber reducer (it has a hose clamp on each end)
2ea. hose clamps to fit over the belt drive inlet & outlet (used with 2" pvc)
about 2ft. of 2" pvc pipe.
a tube of silicone & PVC glue & primer
You may like to wrap the flex pipe in black tape or camo tape. You can paint the hard pvc pipe & fittings. The flex just wouldn't dry.

You WILL have to cut the eng. cover but you can't see it once its back on. I have been in water over the hood / chest deep & it doesn't miss a lick and the belt is dry. It looks good too! If you ride in deep water you will need to remove the side eng fan.

I'm better at talking than typing. Call me. My cell # is in this post.

You can get all of this stuff at home depot.

Robert

 

I sent you a pm RIS