Ok i have a 85 350X and i noticed the bolts on the little plate towards the bottom of the right fork that hold the axle in place were loose and when i went to toghten them the top left one snapped and im pritty sure its a stud and not a bold so i was wandering if anybody knew of any ways i could fix this problem.......any responces would be greatly appreciated.

 

You can try drilling it and using an easeout to remove it. You can also drill it completely out and then just chase the threads with a tap. Just make sure you get it centered so you don't take out any threads. Then screw you a new stud in there.
Good luck,
Ray

 

Thanx man ill run that by my dad

 

thanx man that helped a lot its all fixed.

 

Good job...piece of cake, huh.

Later,
Ray