EX has loose clutch problem
#1
EX has loose clutch problem
heres where it all (possibly) started:
sometime back in december or so, i was riding around in the snow. i whipped in into a snowbank, and bogged out. restarted it, and attempted to put it in first gear, but the clutch would pull all the way in and not engage. i manged to ride it home by starting it in neutral and riding home in first (without the clutch, but i didnt rev it up or anything). ordered a new clutch cable, put it in a week later. then later (march or so), it was getting loose, so i unscrewed the adjuster so theres about 3 threads in, this held off for a while. but now recently its been getting loose again, as i can pull the clutch in almost halfway before it starts to engage, and letting it out the slightest amount (from a full grab) and the quad starts to move. also, pulling it in all the way at a standstill, it is hard to get it into neutral. im for sure taking it into the shop unless anyone has an idea what to do. thanks
sometime back in december or so, i was riding around in the snow. i whipped in into a snowbank, and bogged out. restarted it, and attempted to put it in first gear, but the clutch would pull all the way in and not engage. i manged to ride it home by starting it in neutral and riding home in first (without the clutch, but i didnt rev it up or anything). ordered a new clutch cable, put it in a week later. then later (march or so), it was getting loose, so i unscrewed the adjuster so theres about 3 threads in, this held off for a while. but now recently its been getting loose again, as i can pull the clutch in almost halfway before it starts to engage, and letting it out the slightest amount (from a full grab) and the quad starts to move. also, pulling it in all the way at a standstill, it is hard to get it into neutral. im for sure taking it into the shop unless anyone has an idea what to do. thanks
Thread
Thread Starter
Forum
Replies
Last Post
KimSJoh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
14
07-18-2015 07:20 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)