300ex and rear break not working
#1
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
I just rebuilt the master cylinder on my 300ex, but I cannot get the break to work. My parking break works fine, after fiddeling with it though. If I open the blead screw and press the break, fluid does come out, but sometimes not to much comes out. My lines are clear but not to much fluid will come out. I thought it should kind of stream out.
Help please!
THANKS!
Help please!
THANKS!
#2
#4
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
Actually, gravity should keep air out. If you just open the bleeder at the caliper, and dont do anything else...eventually the fluid will come out. Gravity will take over and expell the air.
If that doesnt work, snug the bleeder, hold the brake pedal down, and open the bleeder. The pedal should slowly go to the limit of its travel, then hold the brke pedal there, while snugging up the bleeder. Dont let the brake pedal return with the bleeder opened.
Is the rezzy full of fluid?
When you rebuilt the master, did you have all the new pieces in the right places?
If that doesnt work, snug the bleeder, hold the brake pedal down, and open the bleeder. The pedal should slowly go to the limit of its travel, then hold the brke pedal there, while snugging up the bleeder. Dont let the brake pedal return with the bleeder opened.
Is the rezzy full of fluid?
When you rebuilt the master, did you have all the new pieces in the right places?
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)