2002 rubicon, sputters in reverse, flashing a code 10. Fail safe ecm?
Book in trouble shooting section says to replace ECM anyone been down this road before and have helpfull hints> thanks..

 

I have the same issue... read this thread:

http://forums.atvconnection.co...atid/8/threadid/520829

 

Yes I Seen that you did, My machine is of course 5 years old, pushed snow, hauled logs and trees and is at the 3,000 mile mark.
Shes been upside down a couple of times and I have had not many issues. Some clicking in the front that turned out to be bad brakes, and a rattle as a certain rpm that I swear was a a heat sheild or just a noise that it makes.

I have had to reset the ecu couple of other times, this time it WOULD not work?



So.......... I took advice from here on the forum and cleaned Almost all conections, blew out with compressed air etc... and low and behold put it back together, did the reset and it works....

Ive just come to the conclusion that ive had a good run with this atv over the last 5 years and some change, Its hauled my 360+lb rear a long way and pushed alot of snow, hauled alot of wood and carried many deer out of woods. Iv grown partial to it, and ive been mad at it a time or to. But in the long run if youll check all my post honda in the end has been good to me Hell they even gave me money back on a repair that I payed for on my wifes atv some 2 years later.