No spark until starter button is released
#1
No spark until starter button is released
Need some help.
I'm not getting any spark when cranking motor over with ele. or rope starter.
When I release starter button it will fire and I can get it to run and it runs
like it should after getting it to start. It has never been in deep water.
I checked all the fues's I could find, all where good. From reading on line
it could be CDI or Rectifier. All the post I found, which where very few.
Poster's never followed up on thread to say if they solved the problem.
Thanks,
TT
I'm not getting any spark when cranking motor over with ele. or rope starter.
When I release starter button it will fire and I can get it to run and it runs
like it should after getting it to start. It has never been in deep water.
I checked all the fues's I could find, all where good. From reading on line
it could be CDI or Rectifier. All the post I found, which where very few.
Poster's never followed up on thread to say if they solved the problem.
Thanks,
TT
#2
i have a 99 trx400 w/ the same problem in regards to the starter button. i can get it started by hitting the starter button and releasing it as i pull the rope. then the engine runs fine at idle but as soon as rpms get above high idle it dies as if the ingnition got turned off. sorry 4 not answering your ??, but maybe somebody will read this and help us both out. i need mine 4 ranch work + so if no response soon it goes to the shop. yuk! i'll let u know what i find out if it does go to the expensive place. good luck w/yours.--AV
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)