help 300ex wont start
#22
#23
#25
just kidding or maybe not but my brother inlaw did the valves for me it has much better compression but it still wont start i dont know where to go from here when i had the carb off today i pushed the throtle and the gas comes out in a mist i remember on my old 2stroke dirtbike it would shoot out in a stream im not sure how its suposed to be on this bike but does that seem like its working right i dont know where to go from here other than to just start parting it out
#26
#28
#29
#30
ok i made some progress today i think i took off the top end i cleaned the piston rings and all the carbon build up off the piston put it all back together set the timming tride to start it same as usual so i sprayed starting fluid in the carb it sounded like it wanted to start so i tride that for about a half hour with nothing so i took off the carb and sprayed it in the hole for the carb and it started for about a second so i put the carb back on sprayed it in the carb still the same as before so i took off the plates on my pipe i have a fmf power max or something like that so now the exuast is upened up i tride the starting fluid in the carb again and it started it ran for about a min maybe a little less i havent tride agian since i dont want to mess anything else up do you think it will be fine now if i let it run for a little bit or what could still be wrong with it? i also cleaned the carb it seams to be spraying out better now too