Ok, I got the regulator sitting on the table in front of me. Fluke is at work, but have my craftsman DVM. Accurate or not, it seems like I should get some type of readings. Following the Honda repair manual I get no reading between most all the wiring? Here is what I did. I do not have the recommended meter as called for in the manual (sawn and kowa).

Meter set at 20k ohms
Red to yellow. No reading
Red to yellow no reading
Red to green no reading
Black to green 0.54 good

Green to yellow no reading
Green to yellow no reading
Black to yellow no reading
Black to yellow no reading
Black to yellow no reading
Black to green 0.54 good
Black to red no reading

0 continuity between the 2 yellow wires is this normal?

Anyone get anything out of this?

George

 

I'm guessing the regulator is junk, but what does the manual say you should have gotten?