TRX250EX ball joint sizes?
#1
TRX250EX ball joint sizes?
Hello all, I'm hoping to find my upper and lower ball joint sizes for my 2003 trx250ex. I need the length and taper so I may find a rod-end type ball joint, or a tapered shaft to run a heim joint to the spindle. I have been scouring for quite some time now for this info, but have come up empty. I'm adding 4" a side to my front control arms, hopefully my the pics of my project will generate interest. Any help or knowledge on the subject is appreciated. Thanks.
#3
#5
An atv on the street, with a swing arm rear, an independent front, and very high spring rates, can get scary. An atv with a correctly setup 4 link rear, and redesigned front, could be much less scary. BTW, I used my TRX250ex as a daily driver for over 40000 miles, never had an issue other than the locked diff, could out corner ANY street bike. Also, my new machine will feature an actual differential, which will help a ton.
#7
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Chasso
2) Chassis problems..
1
09-19-2015 03:06 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)