I just installed a clutch kit on my 2000 Rancher 350ES because it was slipping with hard throttle. Now I can't get it to come out of neutral even when I try the manual hand shifter. It was changing gears fine before I installed the clutch kit. Does anyone have any suggestions. Thanks

 

You may of fixed you initial problem but now your in the E.S trouble. There are hundreds of post on it if you use this site's search feature.
Most common is the angle sensor, but since yours did work right it probably just a little hook up mistake.

 

Thanks. I'll look back over everything.

 

did you have the auto clutch out also? if so may have the one way bearing backwards

 

You could have also have the shift linkage off one spline...this will may shift pattern different

 

Yes I did. It's very possible I have that oneway bearing backwards. Thanks I will check that.

 

I believe the shift linkage on this model has a master spline but I will double check. I'm gonna break it back down in the morning. I will report back on it. I really believe I could have put the one way bearing in backwards. Thanks for your knowledge.