25/26 inch tires on a Honda 300 4x4
#1
I have a 93 Honda 300 4x4 and I'm wondering how it would handle 25/26 inch Titan 589 Tires? It is a totally stock engine. How much power would I loss? How about sportiness? Will they rub? Please Help!!!!
------------------
Honda 300 4x4 Kenda Rampage Tires, 2000lb Superwinch, and Oxlite Bootguards
------------------
Honda 300 4x4 Kenda Rampage Tires, 2000lb Superwinch, and Oxlite Bootguards
#6
Well, not so good.
It had 26x9x11(or maybe it had 12" 450s wheels)TSL's front and rear. Other than that it was totaly stock.
When we had a pull off on soft ground he couldn't even spin the tires, but he did stop me from draging him because I just spun the tires. But on the hard dirt road he could spin the tires, the 20 foot long tire marks from me draging him while he spun proved that.
If all you will be doing is going in thin soupy mud then you shoud not have a problem with the 26" tires(he didn't). If you go in thick mud, or plan on doing any pulling stick with the 25" tires.
I also think that with Highlifter's Performace kit that you were planing on getting will allow you to pull those 26" tires with no fuss at all.
It had 26x9x11(or maybe it had 12" 450s wheels)TSL's front and rear. Other than that it was totaly stock.
When we had a pull off on soft ground he couldn't even spin the tires, but he did stop me from draging him because I just spun the tires. But on the hard dirt road he could spin the tires, the 20 foot long tire marks from me draging him while he spun proved that.
If all you will be doing is going in thin soupy mud then you shoud not have a problem with the 26" tires(he didn't). If you go in thick mud, or plan on doing any pulling stick with the 25" tires.
I also think that with Highlifter's Performace kit that you were planing on getting will allow you to pull those 26" tires with no fuss at all.
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
Jul 22, 2015 05:00 AM
CRamshaw777
Classifieds, Garage Sale & Swap Shop
0
Jul 18, 2015 05:46 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




