Hello everyone. Just joined the site. Lots of good info on hear.
I have a taotao tforce ATA 110cc D/D1bike runs fine but when you put it in gear it dies. I ran the bike in neutral and rolled it along and jumped on while putting it in gear and bike drives along fine with lots of power, once you try to stop it stalls out like the clutch isn’t working. Adjusted clutc as shower in videos. Turned counterclockwise till restriction was felt than back an 1/8. No difference. Any suggestions or should I just put a clutch in it? Thanks in advance.

 

Also put new wet clutch oil in but made no difference.

 

Welcome to the forums.

 

Gear behind clutch has a bushing inside of it which was seized. Replaced bushing and reassembled and bike and clutch work like they should. Hope this helps someone else some day. Had a few of us stumped for a bit.

 

Welcome.