CRASHDOG, I have to run down to the storage unit tonight.....I'll measure it out for ya and give you a shout back.

 

THANKS MARK,

 

wow nice job! you must do some fabricating in your spare time. you should patent it and sell to some company lol

 

hey mark dont forget us on those dimensions,

thanks, crash

 

Great V Mark!!

 

Thanks Mudfoot.....still saving for some nice ELKAs like you have though.

CRASHDOG, I didn't forget about ya......I went down to the storage unit but couldn't get into the electronic gate. For some reason all power was out in the entire area (car probably hit a pole....snow today followed by freezing rain). I can't wait till they finish my house so I can pull all my stuff out of storage and get back to a normal life! I'll get the measurements tomorrow after work.

 

hey mark, how about the scoops ????????????
or can you make me some for a small donation, lol

 

CRASHDOG and anyone else interested in the dimensions of the air scoops please e-mail me at: mncreid@epix.net [img]i/expressions/face-icon-small-happy.gif[/img] Finally got down to the storage unit and measured them.

 

nice looking craftsmanship mark. Also did your bajas have a different offset that stock if so can you tell what it. thank you so much. nice looking 700 and you like mods as much as me lol.

 

Hey Mark, from what I remember the off set on the Bajas was about dead on with the stockers. At the same time I put the rear Bajas on my "V" I also slapped on some 1" wheel spacers to widen the rear end an additional 2". I didn't do this to make up for an off set issue going from stock wheels to Bajas, I did it just to give the rear end a little wider stance. I do specifically remember when I first got the Baja wheels I called ITP to see if they offered different off set choices in these wheels (just to see what my options might be) for the V-Force and at that time they only offered one off set.