P650 now goes 74 mph.
#21
#22
P650 now goes 74 mph.
Man you guys are ATE up but I mean that in a good way[img]i/expressions/face-icon-small-wink.gif[/img]..it's pretty cool to see people have such a passion and are willing to push the envelope on things like this.I know my stock 650 will do 66-67 and that PLENTY for me....my titans feel like they are going to jump off the quad at that speed LOL.Nice pics KOD
02 650 camo
02 650 camo
#23
#24
P650 now goes 74 mph.
Its late, about 1:30 am. I just got in from testing an entire primary clutch assymbly loaned to me by Kevin Johnston. I have found that the ticking is in my movable sheave. There is no way the machine shop could have caused it. Actually its less than before but still there after putting it back together. I guess after 1902 miles it just getting a little worn.
I also found out "after careful measurments" that the sheave was cut .100" and the cover plate was cut roughly .060" like it should be. I have pictures of the measurements in my clutch mod photos along with a lot more new photos of the clutch. I thought it was an aweful lot when he started cutting the sheave. Either his stop point moved some or he measured wrong. Reguardless, Im still very satisfied with this mod and will continue to run it without any further worry about balance or anything else.
Look for the new pictures around 2 am if you are up and read this.
I also found out "after careful measurments" that the sheave was cut .100" and the cover plate was cut roughly .060" like it should be. I have pictures of the measurements in my clutch mod photos along with a lot more new photos of the clutch. I thought it was an aweful lot when he started cutting the sheave. Either his stop point moved some or he measured wrong. Reguardless, Im still very satisfied with this mod and will continue to run it without any further worry about balance or anything else.
Look for the new pictures around 2 am if you are up and read this.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)