Just installed the windshield and plow (P-650) AND DEER PIC
#1
Just installed the windshield and plow (P-650)
The plow was pretty straight forward, only one part left over, and for the life of me, I cant figure it out. It works, lifts fine...54" High Country with manual lift- way faster\cheaper than electric. Still needs a few minor tweaks, other than that, about an hour to completely install and test. Well built, seems ok so far.
The windshield took twice as long as the plow! What a piece of crap! But its on, and I tell ya what, worth every penny and minute. Just took a ride- its 29 degrees without the windchill, took it up to about 30 and what a pleasant ride! Leather gloves, hands didnt get cold, no goggles, no wind burn, no frozen nose. Excellent. I think it was 60.00 shipped
I'm digging the new windshield. The plow means work....LOL
c'ya!
CWG
The windshield took twice as long as the plow! What a piece of crap! But its on, and I tell ya what, worth every penny and minute. Just took a ride- its 29 degrees without the windchill, took it up to about 30 and what a pleasant ride! Leather gloves, hands didnt get cold, no goggles, no wind burn, no frozen nose. Excellent. I think it was 60.00 shipped
I'm digging the new windshield. The plow means work....LOL
c'ya!
CWG
#2
#3
Just installed the windshield and plow (P-650)
Yeah, mine did a 2" plunge when its up. Manual or electric only lifts it so high.
Hey, I blew out my ankle, just got the cast off! yeah, did it on the prairie. Was getting off, twisted it royally filling the deer feeders.
Hey, speaking of deer feeders, check the pic- thats my 9 I got...note the extra hardware
DEER PHOTO
Hey, I blew out my ankle, just got the cast off! yeah, did it on the prairie. Was getting off, twisted it royally filling the deer feeders.
Hey, speaking of deer feeders, check the pic- thats my 9 I got...note the extra hardware
DEER PHOTO
#6
#7
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
TheATVSuperStore.com
TheATVSuperStore
0
09-09-2015 07:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)