Kawasaki Mojave Rear Brakes
#1
Kawasaki Mojave Rear Brakes
Ok, I recently bought a project quad(1991 Kawasaki Mojave). And apparently the previous owner left it sit outside in the weather. So, the rear disk is has a good rust coating on it. And I can't get the disk off so, I have to use it. Now I purchased new brake pads and installed them and bled the brakes. But the brakes are grabbing SEVERELY! I can barely move the quad with all of my might. Does anybody have any ideas on what could be going wrong here? The caliper also doesn't have the parking brake assembly attached to it anymore, so would it not being there have anything to do with it either??? Any help PLEASE!
Thanks, Matt
Thanks, Matt
#3
Kawasaki Mojave Rear Brakes
When you put the new brake pads on, did you clean the caliper up good. The pins that it slides on can get real gunked up and keep the caliper from sliding back and forth even if the piston is working right. that is what happened to mine and it took me two sets of pads to figure out.
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
SixSpeed5
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
8
08-02-2015 05:38 PM
Mojave250A
Performance Mods and Project Quads
1
07-11-2015 10:38 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)