Can anyonr tell me the reset procedure for the belt light on the Praire 360?

 

Here you go...

. Turn the ignition switch OFF.

2. Disconnect both sets of 5 pin connectors located above the CVT cover. Note: These connectors are located just beneath the shift handle on the right side of the 650; one is black and one is grey.

3. Connect these 5 pin connectors to their opposite pairs (grey to black and black to grey).

4. Turn the ignition switch ON.

5. Disconnect the belt failure switch at the 2-pin connector above the CVT cover. (Note: Just follow the wires coming from the rectangular black box on the CVT Cover to locate this connector.)

6. Observe the belt-warning lamp. It should be flashing at a 0.4 second interval for a few seconds then start to flash slower. Let the lamp flash for at least seven seconds.

7. After seven seconds or more, turn the ignition switch off.

8. Reconnect 5 pin connectors to their proper location (black to black, grey to grey).

9. Connect the belt failure switch 2-pin connector (wires from CVT cover).

10. Turn the ignition switch on to confirm that the belt warning light is not flashing. Retry this procedure if needed. As far as I have heard it always works if the belt switch isn't tripped and there are no electrical problems.


I think this is right, if not please jump in if I missed something.

 

thanks I will give it a try.

 

bump