cv joint problem
#1
cv joint problem
I noticed today on my 650 that my cv boot by the wheel poppped off. So I took the whole shaft out and cleaned inside the boot and the joint itself because it sounded pretty gritty. My question is when I went to put the shaft back in, the little metal ring on the end that goes in the front end broke because I used to much force. Is there a trick to get the shaft in without hammering on it and not break the ring? Thanks for any help Brad
#2
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)