I can only get about 30 MPH top speed out of my Dingo 150 and the motor sounds like it's screaming to get that speed out of it. My Kazuma Falcon 110 (the MKI version) is about 3 or 4 MPH faster top speed than my 150 Dingo.

Does anyone offer different size sprockets for these things? Is so, where can I get them? I would like to go down about 3 or 4 teeth in the rear, and up 1 tooth in the front.

 

As shaky as mine is at top speed, not sure I'd want to take her any faster, "she's breaking up captain...."

 

Mine is rock solid at top speed. I found a site that sells sprocket for it. I'm going to get a 23 toothrear sprocket which should get me to 38 Mph.

 

took my 150cc dingo out this morning with hand held gps,i got 30.8 mph,and its screaming and shaking at that speed,kinda scary.

 

I did end up changing the rear sprocket and I got exactly what I said.......38 MPH. That's plenty fast for this ATV.

 

don't think i want to go that fast on it,not very steady,feels unsafe,

 

Hey Prez where did you end up getting the sprocket?

 

From Kazuma. It was $25 and they shipped it out and I got it the next day. You have to order online. They don't take orders over the phone. This was a great purchase for this ATV. Made all the difference in the world. http://www.kazuma-us.com/index.htm

So far so good with this ATV also. Runs like a champ and worth the purchase price. No, it's not a Honda, but it does everything I need it to do and does it well.

 

What did the sprocket do to your low end torque?

Assuming mine tops out at 30, it's pretty funny that my suposed Sunl 50 is 7mph faster than the 150. These Chinese bikes are just wacky!

 

A little loss of low end torque, but not much. The greatest benefit is a much lower RPM at speed than before. Before, at 30 MPH, the engine was screaming. Now at 30, the engine is humming along nicely.