I would like to put wheel spacers on my sons 06 predator 90. Do I put them on all four corners or just the fronts to increase stability? 1, 1 1/2, or 2"?

I understand they are 4/110. Do I get aluminum or plastic? Where do I get em? Any other suspension issues because of these?

Any info is appreciated.


Thanks!

 

You can buy them from racewayatv, or try to make the yourself...

 

I have ran 1" in the front and 1 1/2" on the rear good way to make the quad a little wider i have a set of 1" fronts aluminum that i am selling. P.M me for more info

 

Check on ebay they should have them I have put on 1.5 inch spacers front and back on my Yamaha 80cc. Definetly more stable and does not tip on its side as easy.

 

Oh definetly get the aluminum spacers or steel, I wouldnt trust plastic as far as wheels are concerned. If it is not being jumped hard then I would think about the stud extenders.

 

I got fronts in 1-1/2"aluminum, they bolt up to the hubs and the wheels bolt to them....no longer studs needed.