Ok i got my new clutch cable and clutch handle and before i installed them i checked them out and it all matched fine handle was the same and the clutch cable is the same length but for some reason when i adjust the cable and when i press the clutch in it wont go in gear. Does it have to be in a certain gear when you put it on. Ive already tried everything and i even put back the old cable and didnt want to work and it was working before i put the new cable cause i rode it around the block. Can someone please give me some tips on the best way to adjust cable on Jet 250. Thanks in Advance

 

I am not real familiar with this model, I can only tell you that I replaced a clutch cable on the Blaster and had to open up the clutch case and adjust it in there first. On the Blaster there is a small screw right in the middle of the clutch with a lock nut on it. Just loosen up the nut and give it a 1/2 turn out and tighten up the nut while holding the srew with the screw driver. Sorry for the mis info if it isn't the same.

 

Thanks for the info i actually was thinking that i might have to adjust it in there but well see if i can adjust this weekend thanks for the info.