Hey guys!!! What is the size of the nut on the rear clutch on lt80... I going to remove it and do some mods on clutch......Is it an 34mm socket size?

 

I'll have to go look. I think 1 1/4 is one of the sizes (there are 2..old/new).
FYI: it's left hand thread.

 

1 1/4 and 1 5/16

 

LT80 Thanks alot..............

 

LT80 it s was 1 5/16. this is 1998 model... also correction on my part i said rear nut BUT I meant big nut on clutch on engine..... Thanks Again....

 

I figured it was the big nut by you asking if it was 34mm.
So whatcha doing?

 

LT80, just doing one of our lt80,s we did 1.50mm bore and had carb.ported by wincycles and cut head down,fmf pipe,reeds, air box mod., ratio gearing changed, now doing the clutch mod.. also gone tire and wheel kit,just piddling with this one.. have 4 of theses.....LT80 anything else we may do...?...

 

For what's done, your good.
I'd not mess w/the airbox tho. Just cuz it don't need it.
Carb ported?

 

Yes looks like an dremel was used to trim up inside and round off corners and bout 2mm bigger inside..