Does anyone know where I could find a-arms and a axle from a Moto 440 and how much they cost? I'm thinking about getting them for my Cannibal.

 

how long before you think lonestar and leager will make after market parts for them? i figure they would but cannondales dont go off the floor like hondas do.

 

I'm not 100% sure of this but I believe the Lonestar Excalibur for the Honda quads will work, call Lonestar to verify. I know there are several companies currently designing A-arms for the Cannondale's but the best place to call for info on the aftermarket products is R&S Performance.

 

Their Walsh a-arms are pretty expensive and their titanium axle is VERY expensive. I know Leager will make them since Kory Ellis has them on his Cannibal. Cannondale isn't selling quite like Honda but if you look, the after market parts are starting to roll in pretty quickly. Cannondale must not be doing to bad. Nac's and K&K are also selling Cannondales and parts for them. I thought maybe the moto 440 a-arms and axle might be a little cheaper and I don't have a whole lot of $.

 

Cannondale Moto specific individual parts will not be available as a part to purchase individually for a few weeks after full Moto production get underway. And this is only a Cannondale guess, the Blaze has been shipping for a few weeks and the Blaze specific parts are not available indiviually yet and they can't estimate the date. As in the handguards, nerfs, kill tether switch and plate mount.

It may be a good while before Moto individual parts are ready, they must put their supply to early production first.

That R&S titanium axle is availabele now in steel also.