im gonna try to fit a cr500 engine into my extra warrior frame i have lying in my garage. will i need to cut the frame for it to fit?

 

yes cut, weld, fab, It not an easy job. but can be done.

 

im actually thinking that the warrior frame will be perfect for this project, the warrior doesnt have that good of handling but its mostly going to be a drag bike anyway. i will still have to cut the frame? i thought that the less amount of space that the nonbalanced cr500 motor takes up might fit with only needing a mount fabrication?

 

probley, the wheel base is short so move the motor up a few inches or get a looong swing arm or both

 

do you have the mac racing trx500r?

 

no, I built this one with my brother. he is certified at pipe and tube bending and metal fabication.

 

how bad do you stomp on banshees and R's?

 

I hate saying this but I got beat by a 3-wheeler 370 on alky but my gearing was tooo tall so he got me off the line, beat me by 1- and a half bike lenghs. All other R's and 4-strokes are a joke to race. Banshee's I win alot but lose alot to the alky or big bore drag bikes. still dialing my bike. gonna report and get a bigger carb and run n.o.s, should be puttin around 95-100 hp when i'm done,then ill spank most banshees but not all.