Keihin 39 PWK jetting on LT250
#1
Guys
setting up a Keihen PWK 39mm carb on my modded lt 250, any guidelines on base line jetting would be appreciatated to speed up the "dialing" process.
Kiwi Craig
http://www.geocities.com/kiwi_craig/
setting up a Keihen PWK 39mm carb on my modded lt 250, any guidelines on base line jetting would be appreciatated to speed up the "dialing" process.
Kiwi Craig
http://www.geocities.com/kiwi_craig/
#2
52 Pilot, Air screw 1 1/2 turns out, CEL Needle 3rd clip pos(middle), is it piped?? 165 Main, ported?? 175 main.
Note on the needle I've used this needle in a few motors that I have set-up(Mainly for duning). It's a pretty lean needle, so if you do alot of partial throttle cruising, I would reccommend using a DEJ or DDG instead.
Note on the needle I've used this needle in a few motors that I have set-up(Mainly for duning). It's a pretty lean needle, so if you do alot of partial throttle cruising, I would reccommend using a DEJ or DDG instead.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)