Scrambler 400 starter I've had it!!!!!
#1
Scrambler 400 starter I've had it!!!!!
WHo has had there 400's starter go bad. The bendix sucks and the starter has a mind of it's own.
I must have replaced my starter twice and rebuilt it to many times. as for the bendix it to has been replaced and rebuilt and cleaned but, it always fails. IT dosen't even matter if it is sealed in the case good or not it still fu(KS up.
THis last time got me though. I got a starter rebuild kit(had no problems do that) I looked at the bendix and it had no signs of wear and I even replaced the bushings that the bedix rides in .It all worked great after i put it back together.then I went to start it for a ride and CLICK,CLICK,CLICK nothing!!!!Needless to say I was pissed.
After riding for a hour it worked again,ontill it was time to go into the truck. now I'm thinking I'll take it off all together.
I must have replaced my starter twice and rebuilt it to many times. as for the bendix it to has been replaced and rebuilt and cleaned but, it always fails. IT dosen't even matter if it is sealed in the case good or not it still fu(KS up.
THis last time got me though. I got a starter rebuild kit(had no problems do that) I looked at the bendix and it had no signs of wear and I even replaced the bushings that the bedix rides in .It all worked great after i put it back together.then I went to start it for a ride and CLICK,CLICK,CLICK nothing!!!!Needless to say I was pissed.
After riding for a hour it worked again,ontill it was time to go into the truck. now I'm thinking I'll take it off all together.
#2
#4
#5
#6
#7
Scrambler 400 starter I've had it!!!!!
Sounds to me like your battery needs to be checked, Sounds like it it only maintaining a service chg and does not have any cranking amps left to run the starter or you are have too much voltage drop between the battery and ground or the battery and starter also ck your starter relay, bypass it and see if it cranksCk all your connections at the battery ground and the engin ground the engin ground might have broke off from the flexing of the engin
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)