PREDATOR POPPING CDI
#1
PREDATOR POPPING CDI
WELL I have Found the rev limiter.I tried jetting it but, it wasn't the cause of the backfiringand popping!
SO now I'm at that point where I don't know what to do>
FRIST OFF WHY IS tHAT REV LIMITER SO DAM LOW!!!!!!
I HAVE never hit a rev limiter on a yamaha RAptor, Even One that is highly modded. What is up with that.Polaris needs to fix this>
Anyway What kind of CDI can I get? I'm not looking to spend A ton of money For a Cdi with tons of Curves.
What kind of prices Am I looking at. anyting Less then a HPD One.
Also Maybe one of you Knows If you can just cut the wire that controls the rev Limiter. If SO what Colour wire is it>
I only have a slip on W/b silencer Dyno jet kit and K+n filter and I don't need much more other then a little higher rev without popping
HELP me!!!!!!
SO now I'm at that point where I don't know what to do>
FRIST OFF WHY IS tHAT REV LIMITER SO DAM LOW!!!!!!
I HAVE never hit a rev limiter on a yamaha RAptor, Even One that is highly modded. What is up with that.Polaris needs to fix this>
Anyway What kind of CDI can I get? I'm not looking to spend A ton of money For a Cdi with tons of Curves.
What kind of prices Am I looking at. anyting Less then a HPD One.
Also Maybe one of you Knows If you can just cut the wire that controls the rev Limiter. If SO what Colour wire is it>
I only have a slip on W/b silencer Dyno jet kit and K+n filter and I don't need much more other then a little higher rev without popping
HELP me!!!!!!
#4
PREDATOR POPPING CDI
To be honest with you I believe that the rev limiter is kinda low as well and do not like it but, I have found that if I shift before I get close to it the bike just keeps pulling and is faster than if I ride the border of the limiter. If you can, try short shifting a little bit, if not Rath, Vortex and others offer an aftermarket box. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Scooter's Shop
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
23
10-22-2015 07:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)