Torque on front hub nut?
#1
#2
#4
![Default](https://atvconnection.com/forums/images/icons/icon1.gif)
The factory spec is 108 inch/pounds. I think it is very inportant to have it torqued to this as other wise you will have it to tight with will be hard on the bearings or you will have it too loose and everything will move around. If Polaris didn't think it was that critical they would never have give a torque spec. I know that it is a lot tighter than when doing trailer bearings so I would be careful. I would try to rent or borrow a torque wrench instead of guessing because if you guess and it is wrong the money it will cost you could have bought a torque wrench for each day of the week. GOOD LUCK[img]i/expressions/face-icon-small-smile.gif[/img]
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)