oops..
#1
oops..
ooooppssss!
i finally took the time to look at the owners manual and it says that i should basically take it easy the first 10 hours of use, welll i've ridden it 3-4 hours so far and already pinned it on a straight away about 5 times, once while racing, i've taken it through rough trails, a grass field, up a big, steep hill, while pinning it, and through a little bit of water? Should i have to worry about my engine now? by doing that did i cut down on it's life or will it still last me a good while. i guess i should've known i had to break it in before doing that stuff to it, hopefully i didn't affect anything, i mean it still goes just like new, except i find that when i take of the bars stick to the right, all i do is stop, turn them and they straighten out, is this something to worry about, should i go get that checked?
i finally took the time to look at the owners manual and it says that i should basically take it easy the first 10 hours of use, welll i've ridden it 3-4 hours so far and already pinned it on a straight away about 5 times, once while racing, i've taken it through rough trails, a grass field, up a big, steep hill, while pinning it, and through a little bit of water? Should i have to worry about my engine now? by doing that did i cut down on it's life or will it still last me a good while. i guess i should've known i had to break it in before doing that stuff to it, hopefully i didn't affect anything, i mean it still goes just like new, except i find that when i take of the bars stick to the right, all i do is stop, turn them and they straighten out, is this something to worry about, should i go get that checked?
#4
oops..
Sounds like you have a 4x4 scrammy.The pull to the side is the front hubs not dis-engauging all the way.Just back up a little to let go and take off in forward again.As for the engine,it's not hurt.They tell you that so you can get familar with the bike.But, the engine does produce a bit more heat when new which can transfer to the plastic and close fitting parts and melt it.
#7