I'll do that. Maybe i will paint it silver so it looks like billet.

 

Stopped by Sam's today to check out the Crewline lift and it is nice for the money ($78)!

also seen some other good deals for ATV /Auto...FYI


--REL Tri-fold T6 Alum. 48" 1,200 lb. ramps........model #1-71506................$96

--Crewline 2 ton Alum. floor jack (45 lbs.)..............model #480750 ................$78 (nice alum. quality construction)

--Crewline Alum. creeper........................................... model #480651 ................$25

--Champion (Exide) ATV / Motorcycle batteries......................................... ...........$23-38 (Scrambler/TB 14A-A2 $29)

Jim

 

so did you end up getting the crewline lift? I would like to get the crewline floor jack too

 

No not yet, I didn't have the frikin card with me and they wouldn't let me do it. I guess I could have paid the 5% over like a guest visitor but I'll just get it this weekend. I live close by the Sterling Hghts. location.

The car jack looked nice too and I wouldn't mind getting one of those too!

Thanks for the heads up guys on all the great buys, you guys are going to be costing me a lot of money![img]i/expressions/face-icon-small-happy.gif[/img]

Good thing I'm not married (anymore).[img]i/expressions/face-icon-small-wink.gif[/img]

Jim

 

you guys are getting me all worked up!!!!

Im gonna have to go buy 8 or 12 of these things[img]i/expressions/face-icon-small-disgusted.gif[/img][img]i/expressions/face-icon-small-happy.gif[/img][img]i/expressions/face-icon-small-mad.gif[/img][img]i/expressions/face-icon-small-shocked.gif[/img][img]i/expressions/face-icon-small-tongue.gif[/img]

 

I bought one but I think I might have a problem. I would guess the handle moves in about a 90 degree arc. I was expecting it to raise during the 90 degree pump. Instead I only get about a 1/3 of the bottom of the stroke actually lifting the jack. What is everyone else seeing?

 

read the first page, I had to bleed/purge air from my pump when I got mine then the handle pumped from a higher position. follow the instructions in the fill fluid/purge air section of the white sheet that came with the lift.

 

Went out and bought a Champion Hydraulic Table lift. Says it will lift up to 660 lbs. I have lifted my 99 scrambler 4x4 a couple times and it seems to work with out any problems.....Text

 

Thansk silverbullet,

When I first set it up I had nothing to pump up. So I bled per instructions and got the 1/3 pump stroke lift. Bled 2 more times and no change.

So you are getting lift on the full pump arc?

 

not from a 90 degree angle which is full up position. It starts to pump at about a 60 degree angle (not exact but it's something over 45 degrees). I purged/bled the air a few times, I did it a couple times the way the instructions say to do it and then I pumped it by hand all the way up and then opened the purge screw then released the pressure with the handle a few times and got some more air out. I wonder if adding a bit more jack oil would help it to pump more.